H12-425 HCIP-Data Center Facility Deployment Questions and Answers

If the customer load cannot be power-off, what should be taken care when closing the maintenance bypass switch?

One skylight actuator can drive a maximum of ( ) skylight magnetic locks at the same time.

The more PUE value of a data center is close to 1, the better energy usage efficiency is.

DOD is the ratio of discharge battery capacity to the rated battery capacity, expressed as a percentage.

The higher the battery charging current is the better.

Users can monitor devices such as UPS and air conditioner on ECC800.

To modify the micro-module view of ECC800,users need to log in the WebUI as as admin.

NetCol5000-A25 kW uses as thermal expansion valve.

NetEco can’t send work orders to processors.

The indoor fan does not work when the NetCol5000-A is started, the possible reason is that ( ).

Which are the high reliability features of NetCol5000-C?

In the process of disconnecting the battery pack switch, if there are multiple sets of batteries, first disconnect the main switch between the battery pack and the UPS, and then disconnect the switch of each battery pack

The work modes of rotary wheel free cooling solution are ().

If the rotation function of the teamwork is enabled, the active and the standby air conditioners can work alternatively to prolong their service life.

For NetCol5000-A, if a meter detect that no current passes through the infrared humidifier, it indicates that the lamp is damage.

After the hot backup function is enabled for the NetCol5000-C, all the unit is settled as running unit.

To balance the capacity loss caused by the self-discharge of the battery during the use of the battery, it is necessary to charge the battery continuously and for a long time at constant voltage, which is called ().

Two UPS2000-G with different software version can be connected in parallel.

Linkage of the multi-functional sensor and skylight can be set on the ( ) menu of ECC800.

Which of the following factors affect VRLA battery life?

The NetCol5000-A25 kW supports light load dehumidification.

If IP21 component is configured, top cable routing is not supported for UPS5000-E.

After the battery discharge deeply, it should be ()

NetCol5000-C temperature and humidity sensor dial setting is incorrect may result in ().

Users can modify IP Address of the ( ) menu.

To set the remote alarm notification on the NetEco, you need to ( ).

The ATS/MCCB input unit of an integrated UPS is used to ( ).

If UPS5000-E works in maintenance bypass mode, bypass module cannot work.

On the NetEco, the door name can’t be modified.

In the FusionModule1000, all surface-mounted fire control cables are rounded through metal hoses to prevent damage in case of fire.

In direct ventilation mode, the direct ventilation system exchanges heat between outdoor cool air and indoor hot air.

For the half sized NetCol5000-A25 kW, when preserve positive pressure, the pressure is ( ) MPa

Whether the water distribution unit is equipped or not is based on installation scenarios