210-010 VCE Vblock Systems Deployment and Implementation - Core Exam Questions and Answers

You are assigned to deploy a new host in a Vblock System, with block storage attached.

Which type of zoning would be performed on the Cisco 9148 switch to accomplish this task?

A Vblock System 720 has been configured in the factory according to the VCE Logical Build Guide.

Which statement is correct?

You are required to log in to a Cisco UCS C220 CIMC to validate the firmware.

What are two ways to launch and obtain the login prompt? (Choose two.)

In the Vblock System 720, what describes the VCE standard method of zoning?

After the installing the Cisco Nexus 1000V, the administrator uses the command show svs connections.

This command shows the connection status of which component?

What is the boot LUN size for an ESXi installation on a Vblock System 320?

You deploy EMC Ionix UIM/P in a Vblock System.

Which two prerequisites must be met before proceeding with deployment of the appliance? (Choose two.)

A SAN administrator must use the zone commit command to activate a zone set on a Cisco MDS 9148.

Which feature is enabled on the switch?

On which operating system is the EMC Ionix UIM/P virtual appliance based?

During a Vblock System 320 deployment, the customer wants to disassociate four half-width blades in a single chassis for a future project.

Which tool is used to perform this compute reconfiguration?

What information is displayed when an administrator uses the show vsan membership command on a Cisco MDS switch?

VCE support asks you to collect VMware diagnostic logs from an ESXi host.

Which two management tools would you use to accomplish this task? (Choose two.)

During a Vblock System 320 deployment, the implementation engineer needs to access UCS Manager to verify the compute configuration.

Which two IP addresses are used to open the GUI? (Choose two.)

-- Exhibit --

-- Exhibit --

Click the Exhibit button.

Vblock Systems have multiple power connector capabilities.

Which power receptacle is shown in the exhibit?

A host has been placed into maintenance mode in a Distributed Resource Scheduler (DRS) enabled cluster for patching. The virtual machines have not migrated as expected. DRS settings have been verified as fully automated at the cluster level.

What would cause this condition?

The implementation profile located in the Logical Configuration Survey (LCS) identifies if the customer will be using which two solutions? (Choose two.)